board.h

Go to the documentation of this file.

/*
 * SPDX-FileCopyrightText: 2017 Inria
 * SPDX-License-Identifier: LGPL-2.1-only
 */
 
#pragma once

 
#include "cpu.h"
#include "periph_conf.h"
#include "board_common.h"
#include "arduino_pinmap.h"
#include "periph/gpio.h"
 
#ifdef __cplusplus
extern "C" {
#endif

#define ATA8520E_PARAM_SPI         SPI_DEV(1)
#define ATA8520E_PARAM_CS_PIN      GPIO_PIN(PA, 14)
#define ATA8520E_PARAM_INT_PIN     GPIO_PIN(PB, 9)
#define ATA8520E_PARAM_POWER_PIN   GPIO_PIN(PA, 28)
#define ATA8520E_PARAM_RESET_PIN   GPIO_PIN(PA, 27)

#define LED0_PIN            GPIO_PIN(PA, 20)
 
#define LED_PORT            PORT->Group[PA]
#define LED0_MASK           (1 << 20)
 
#define LED0_ON             (LED_PORT.OUTSET.reg = LED0_MASK)
#define LED0_OFF            (LED_PORT.OUTCLR.reg = LED0_MASK)
#define LED0_TOGGLE         (LED_PORT.OUTTGL.reg = LED0_MASK)
 
#define LED0_NAME           "LED(Green)"
 
#ifdef __cplusplus
}
#endif