board.h

Go to the documentation of this file.

/*
 * SPDX-FileCopyrightText: 2018 Gunar Schorcht
 * SPDX-License-Identifier: LGPL-2.1-only
 */
 
#pragma once

 
#include <stdint.h>


#define BTN0_PIN        GPIO34

#define BTN0_MODE       GPIO_IN

#ifndef BTN0_INT_FLANK
#define BTN0_INT_FLANK  GPIO_FALLING
#endif

#define BUTTON0_PIN     BTN0_PIN

#if MODULE_OLIMEX_ESP32_GATEWAY
#define LED0_PIN        GPIO33
#define LED0_ACTIVE     (1)     
#endif

#if (MODULE_SDCARD_SPI && MODULE_OLIMEX_ESP32_GATEWAY) || DOXYGEN
#define SDCARD_SPI_PARAM_SPI        SPI_DEV(0)
#define SDCARD_SPI_PARAM_CS         GPIO13
#define SDCARD_SPI_PARAM_CLK        SPI0_SCK
#define SDCARD_SPI_PARAM_MOSI       SPI0_MOSI
#define SDCARD_SPI_PARAM_MISO       SPI0_MISO
#define SDCARD_SPI_PARAM_POWER      GPIO_UNDEF
#endif

#if MODULE_ESP_ETH || DOXYGEN
#define EMAC_PHY_LAN8720        1                   
#define EMAC_PHY_ADDRESS        0                   
#define EMAC_PHY_SMI_MDC_PIN    23                  
#define EMAC_PHY_SMI_MDIO_PIN   18                  
#define EMAC_PHY_CLOCK_MODE     ETH_CLOCK_GPIO0_IN  
#define EMAC_PHY_POWER_PIN      GPIO_UNDEF          
#endif
 
/* include common board definitions as last step */
#include "board_common.h"
 
#ifdef __cplusplus
extern "C" {
#endif
 
#ifdef __cplusplus
} /* end extern "C" */
#endif