board.h

Go to the documentation of this file.

/*
 * SPDX-FileCopyrightText: 2021 Freie Universität Berlin
 * SPDX-License-Identifier: LGPL-2.1-only
 */
 
#pragma once

 
#include "board_nucleo.h"
 
/* Required for `nucleo_wl55jc_sx126x_set_rf_mode` */
#if IS_USED(MODULE_SX126X_STM32WL)
#include "sx126x.h"
#endif
 
#ifdef __cplusplus
extern "C" {
#endif

#define SX126X_PARAM_SPI                    (SPI_DEV(0))
 
#if IS_USED(MODULE_SX126X_STM32WL)
extern void nucleo_wl55jc_sx126x_set_rf_mode(sx126x_t *dev, sx126x_rf_mode_t rf_mode);
#define SX126X_PARAM_SET_RF_MODE_CB         nucleo_wl55jc_sx126x_set_rf_mode
#define SX126X_PARAM_TYPE                   SX126X_TYPE_STM32WL
#endif

#define LED0_PIN_NUM        15
#define LED0_PORT           GPIO_PORT_B 
#define LED0_PORT_NUM       PORT_B
 
#define LED1_PIN_NUM        9
#define LED1_PORT           GPIO_PORT_B 
#define LED1_PORT_NUM       PORT_B
 
#define LED2_PIN_NUM        11
#define LED2_PORT           GPIO_PORT_B 
#define LED2_PORT_NUM       PORT_B

#define BTN0_PIN            GPIO_PIN(PORT_A, 0)
#define BTN0_MODE           GPIO_IN_PU
#define BTN1_PIN            GPIO_PIN(PORT_A, 1)
#define BTN1_MODE           GPIO_IN_PU
#define BTN2_PIN            GPIO_PIN(PORT_C, 6)
#define BTN2_MODE           GPIO_IN_PU

#define FE_CTRL1            GPIO_PIN(PORT_C, 4)
#define FE_CTRL2            GPIO_PIN(PORT_C, 5)
#define FE_CTRL3            GPIO_PIN(PORT_C, 3)
 
#ifdef __cplusplus
}
#endif
 
#include "stm32_leds.h"